|
print-friendly
version
Adulticiding
Adulticiding,
the control of adult mosquitoes, is the most common form of mosquito
control used today. This process can be achieved through aerial
or ground application of insecticides designed to control adult
mosquitoes. The Collier Mosquito Control District (CMCD) uses aerial
adulticiding as the major control method. This is due primarily
to the fact that CMCD is located adjacent to the Florida Everglades
and the 10,000 Islands area which produce huge numbers of salt marsh
mosquitoes that migrate into the District.
The
aerial application of adulticides allows the district to treat areas
that are either inaccessible or too large to be treated effectively
from the ground. Aerial application treats mosquitoes while they
are in flight and vulnerable to the application. This allows mosquito
control operations to treat large populations of mosquitoes at once.
However, there are several important factors that have to be considered
in order for mosquito control to be most efficient, such as species
susceptibility to insecticide, whether the target species is diurnal
(active in the day time) or crespuscular (active after dusk), the
proper dosage rate of the insecticide, and the environmental conditions
at the time of application. Without this information, aerial application
of adulticide would not be effective.
There
are two common forms of adulticiding; thermal fogging, and ultra
low volume (ULV) application. Thermal fogging uses the exhaust heat
from an aircraft's engine to atomize diluted mixtures of petroleum
and insecticide. Ultra low volume application uses less insecticide
than thermal fogging. This process creates fine droplets of pesticide
as it flows through hydraulic nozzles in conjunction with the high-speed
air stream created by the aircraft. The ULV application has less
effect on non-target species because the amount of insecticide is
reduced and the petroleum is eliminated completely. The CMCD began
phasing out thermal fogging in the early 1990's. Since then, the
District focuses on ULV application using Baytex and Dibrom as insecticides.
All
fixed wing applications are currently made at night, usually at
2 a.m., because more mosquitoes are active at this time and to take
advantage of better environmental conditions. At this time of the
night the earth has cooled so there are no thermal convection currents
rising from the ground, which could prevent the insecticide being
applied from reaching the target area. The wind has generally stabilized
in both directions, usually from the east, and speed, generally
under 10 m.p.h. at ground level. In addition, it is too early in
the morning for ground fog, which can limit aircraft operations,
to form.
The
CMCD's practice of adulticiding has changed dramatically over the
past decade. For example, in 1989 it took five fixed wing aircraft
over three days to treat 85 sq. miles (using thermal fogging). This
used 170 gallons of insecticide and 8,500 gallons of petroleum.
The mixture was sprayed out at 20 oz. per acre during the first
hours after sunrise. Not only did this method affect non-target
species because the amounts of pesticide petroleum were so great,
but it was less effective than current practices because fewer mosquitoes
are active during the day. In addition, this cost the district $65,000.
In
1995 it only took two fixed wing aircraft one night to spray the
same area, applying only 0.66 oz. of insecticide per acre. The treatment
was done at night so more mosquitoes were controlled, and fewer
non-target species affected. The amount of insecticide used was
also drastically reduced. This application cost $43,000.
Today,
it takes one fixed wing aircraft less than three hours to treat
the same area, and uses 0.21 oz of insecticide per acre when taking
drift into account. This amounts to $9,500 for application. All
treatments are applied before or at dawn, so fewer non-target species
are affected. However, the CMCD is still focusing on improving the
level of mosquito control while reducing potential environmental
effects and reducing the cost of control. The District has designed
a new air assist spray system that is installed on all the fixed
wing aircraft and one helicopter. The air assist spray system is
new to the helicopter and will be used for the first time during
the summer of 2002.
How do adulticides kill mosquitoes?
Most adulticides work by disrupting the nervous system of a mosquito.
The mosquitos nervous system consists of a brain and neurons.
Neurons are nerve cells that transmit messages to organs in the
body. Adulticides stop the message from being correctly sent through
the neuron which causes the nervous system to overload and stop
functioning. Without the nervous system functioning properly, the
insect cannot survive, and therefore dies.
The
nerve cells are stimulated by electrical impulses that travel between
neurons in a space called a synapse. The electrical impulses given
to the neuron are commands that tell the neuron to do something,
or to stop doing something. The signals that stimulate the neuron
to do something are carried by a chemical called acetylcholine.
The stimulating signals are stopped by a chemical called acetylcholinesterase,
which is an enzyme. The acetylcholinesterase breaks down the acetylcholine,
which stops the message transmission. These chemical reactions occur
constantly, at a very fast rate, with acetylcholine stimulating
the neuron and acetylcholinesterase ending that signal. A muscle
contraction is an example of an activity produced by this chemical
reaction. The brain sends a signal, or nerve impulse, with acetylcholine
through the synapse between the nerve and the muscle, stimulating
the muscle to contract. After the movement is accomplished, acetylcholinesterase
is released. This breaks down the acetylcholine and stops the stimulation
of the muscle to contract.
When
an adulticide penetrates the skin of a mosquito, it travels to the
synapses in the nervous system and prevents the acetlycholinesterase
from breaking down the acetylcholine. For this reason, adulticides
are referred to as cholinesterase inhibitors. This means that the
signals being sent to the nerves are not stopped. If these signals
are going on constantly at a very fast rate, and the acetylcholine
is not being broken down, then there is a build up of acetylcholine
in the nervous system. The excess acetylcholine overloads the nervous
system and the mosquito dies. For example, the brain sends a message,
through acetylcholine, for a muscle to contract. Once the muscle
movement is complete, the adulticide stops the release of acetylcholinesterase.
That means the muscle keeps getting the message to contract. This
causes uncontrolled, rapid muscle twitching which eventually kills
the mosquito.
Source:
Collier Mosquito Control District
|